Only water distiller on the market with faucets that are ALL STAINLESS STEEL.  Other distillers use plastic housings, with rubber gaskets and plastic nuts in the inside of the tank to hold it on. Ours does not !
 
 
 
 
 
 

Larger Drain than most other water distillers.  Although some distillers claim they have such and such size valve, most taper down into a 3/8" tube restricting flow.  Our distiller is a FULL 1/2" drain tube, allowing easier draining.
 
 
 
 
 
 

These are the devices that detect the water level in the boiling chamber and holding tank. Detection is done via conductance, eliminating ALL mechanical switches, moving parts, and seals other water distillers use for detecting water level.  This eliminates many of the failure parts in most other water distillers, and eliminates PLASTIC float sitting in your water.
 
 
 

This is the heart of all auto fill American Water Distillers.  This circuit eliminates the necessity of manual sterilization.  Our water distillers sterilize themselves on a regular basis, eliminated the need to manually sterilize the unit, and also sterilizing it more often, keeping your distiller germ free!
 
 
 
 

Stainless Steel coil, with Volatile Escape Vent, and electronic circuit board.  Also, our fan is protected with a shroud, eliminating the possibility of the coil hitting the fan blade during shipping.
 
 
 
 

Water Distiller Solenoid Valve, stainless steel construction.  Also notice on the right, that is where the water line is connected to an outline water source.  The connector is made out of stainless steel, not plastic.  Our water distillers are the only ones were aware of constructed with such high quality material.
 
 
 
 

Only Water Distiller on the market with a Stainless Steel Heating Element!  Other distiller elements are similiar to what is used in an oven, and crack/break easy during cleaning.
 
 
 
 
 
 

And of course, in the rare instance something breaks, we have parts, IN STOCK!  No Down time!
 
 
 
 

 

Dimensions: 18" High 18" Long 12" Deep Weight:  51 Lbs model 9C  Electrical:  120V 1200 Watt (Other voltages available) Coconut Charcoal Carbon pre Filter good for 1,500 Gallons Purity:  0 PPM on TDS   > 99.9 Percent Purity. (9C Model)

 

Super Large Carbon Filter removes VOC's prior to distillation.  Eliminating possibility of collected contaminants being released from filter directly into distilled water at saturation point of filter.  Last 1 1/2 years if you make 3 gallons a day.

 

Volatile chemicals that boil at a temperature lower than water (chlorine is a good example), unless removed prior to distillation, will either go back into the distilled water or, more commonly, be vaporized into the air of your home. Breathing them is as bad as drinking them. The best policy is to filter the water through carbon before distilling it. Our water distiller removes them PRIOR to distillation!  No dangerous VOC's will be released into your house to breath!

 

Made out of 304 Stainless Steel. No Plastic faucet, no plastic fittings, no plastic float parts, no plastic lid knobs ! 

 

More parts on out water distiller are made out of stainless steel than any other water distiller on the market.

 

GAC system also reduces hard water deposits, meaning less cleaning.

 

Auto Sterilization, keeps water distiller germ free.

 

V shaped boiling chamber.

 

NO PLASTIC or rubber gaskets that touch the water in the boiling chamber.

 

No floats or mechanical devices to get knocked around or out of alignment during shipment.

 

1 Piece unit, no assembly or wiring necessary. Much easier and quicker to hook up compared to other water distillers.  Most other water distillers require the top to be hooked up to the bottom, and screws/nuts/rubber washers must be held tightened up from the INSIDE of the holding tank of the water distiller, which is not easy. And wiring harnesses must be attached.  Our drain valves are already installed on the water distiller.  All the customer has to do with our water distillers is screw the faucet on the front by hand, no tools needed, and attach an incoming water line to the distiller.  No other automatic water distiller is this easy to hook up.

 

Water distiller has a completely removable boiling chamber lid, which provides the easiest access in the industry to the stainless steel boiling chamber itself.

 

All American Water Distiller functions are controlled by modern solid-state circuitry. All American Water Distiller  units have no mechanical floats, float seals or microswitches to leak, fail, leach, or require replacement. And the plug-in connectors make servicing the water distiller a breeze!.

 

Illuminated Switches!

 

 
 
 
 

We hope you appreciate our BUY DIRECT marketing method, that cuts out the middle man, and saves you $$$$$  Instead of distributors and dealers taking a cut, we put the savings in your pocket!  Giving you a far superior product, at a lower price by selling direct

Accepts Auto Pumps & Auto Drains